


Facade varnish for stone - on an organic basis
Facade varnish for stone, organic-based | ТУ У 20.5-39517487-001:2015 |
---|---|
Surface preparation: |
carried out in accordance with ДСТУ-Н Б А.3.1-23: 2013. Before applying the varnish, clean the surface from dirt, efflorescence, sand, dust, dirt, building dirt, moss, fungi and other substances that reduce adhesion. Remove weak areas and old coatings. In case of detection of areas affected by mold, the cause of its formation should be determined and eliminated. The working surface must be dry (humidity of concrete surfaces is not more than 4%), relative air humidity is less than 80% |
Application: |
Execution of work: mix the varnish thoroughly before use, and also mix during work for even distribution. Apply at temperatures above 0˚С and relative humidity not more than 80%. Apply the varnish with a brush, paint brush or spray gun (on large surfaces), roller. Stone, brick, concrete, asbestos-cement, plastered, cement-sand surfaces are usually covered in three layers. After drying, to achieve the effect of "wet stone", it is recommended to apply another 1-2 layers. The application of the next layer is carried out after complete drying of the previous one, not earlier than 7 hours later at a temperature of 20˚С and relative air humidity of 60%. In other conditions, the drying time of the varnish may vary. Ventilate the room well during and after work. Applying varnish at sub-zero temperatures (up to -10˚С) is possible, but not recommended, since even in the absence of ice and frost on the surface, there may be frozen water in the capillaries, which will not allow the surface to be impregnated with high quality. At sub-zero ambient temperatures, the exposure time increases by 2-3 times. |
Consumption: |
8-12m²/l depending on the type of surface and painting tool |
Retail trade capacity: 10l, 2,8l |
|
Shelf life: |
In dry conditions, at temperatures above +5˚C on pallets in original, undamaged, hermetically sealed containers for 18 months. Keep away from sunlight. |
Cleaning of working tools: |
Immediately upon completion of work, wash the tools in white spirit, then with water and detergents. |
Composition: |
Acrylic with the addition of organic solvents with a high degree of evaporation, modifiers |
Precautionary measures: |
Perform work in protective gloves and working uniform. Clean tools immediately after use with solvent. Do not pour soil into sewers, water bodies. Dispose of liquid residues to a waste collection point. Empty containers and dry residues can be disposed of as construction waste. |
Made in Ukraine : |
manufacturer LLC "Scientific and Production Enterprise Bionic House" |